Front Panel Leds - Cisco 380 Series Hardware Installation Manual

Chapter
Item Port
1
2
3
4
Status LEDs and Buttons
This section describes the location and meaning of LEDs and buttons and includes the following topics
•
•

Front Panel LEDs

Figure 1-7
Figure 1-7
OL-29172-01
Description
P1 Indicates proxy port. Connect P1 to the network for both
incoming and outgoing traffic.
P2 Indicates proxy port. When both P1 and P2 are enabled, you must
connect P1 to the internal network and P2 to the Internet. P1 and
P2 can connect to L4 switch, WCCP router, or network switch.
T1 Indicates traffic monitor port T1 for Duplex Ethernet tap: One
cable for all incoming and outgoing traffic.
T2 Indicates traffic monitor port. Simplex Ethernet tap: Ports T1 and
T2. One cable for all packets destined for the internet (T1), and
one cable for all packets coming from the Internet (T2).
Front Panel LEDs, page 1-7
Rear Panel LEDs and Buttons, page 1-10
shows the front panel LEDs.
Front Panel LEDs
1 2
Table 1-1 defines the LED states.
Cisco 380 and Cisco 680 Series Hardware Installation Guide
3
4
5
6
7
8
9
1-7