Error Codes - HP Linear Barcode Scanner II User Manual

Indication
Label programming mode
acceptance of programming
Label programming mode
cancel item entry

Error codes

Upon startup, if the scanner sounds a long tone, this means the scanner has not passed its automatic Selftest
and has entered FRU (Field Replaceable Unit) isolation mode. If the scanner is reset, the sequence will be
repeated. Press and release the trigger to hear the FRU indication code.
The following table describes the LED flashes/beep codes associated with an error found.
Number of LED flashes/beeps
1
2
6
11
18 Appendix B LED and beeper indications
Description
Configuration option(s) have
been successfully programmed
via labels and the scanner has
exited programming mode.
Cancel label has been scanned.
Error
Configuration
Interface PCB
Digital PCB
Imager
LED
N/A
N/A
Corrective action
Contact Helpdesk for assistance.
Contact Helpdesk for assistance.
Contact Helpdesk for assistance.
Contact Helpdesk for assistance.
Beeper
Scanner sounds one high-
frequency beep and four low-
frequency beeps followed by
reset beeps.
Scanner sounds two times at
low frequency and current
volume.