Selecting The Interface Type; Configuring The Interface - HP Linear Barcode Scanner II User Manual

5

Selecting the interface type

Upon completing the physical connection between the scanner and its host, scan the appropriate barcode to
select your system's correct interface type. Information and programming options for each interface type are
provided in this chapter. For defaults and additional information, refer to the PRG.

Configuring the interface

Scan the appropriate programming barcode to select the interface type for your system.
NOTE: Unlike some other programming features and options, interface selections require that you scan only
one programming barcode label. DO NOT scan an ENTER/EXIT barcode prior to scanning an interface selection
barcode.
Some interfaces require the scanner to start in the disabled state when powered up. If additional scanner
configuration is desired while in this state, pull the trigger and hold for five seconds. The scanner will change
to a state that allows programming with barcodes.
USB-COM
Download the correct USB Com driver from http://www.hp.com/support.
USB-OEM
6 Chapter 5 Selecting the interface type
USB COM to simulate RS-232 standard interface
Select USB-COM-STD
USB-OEM
(can be used for OPOS/UPOS/JavaPOS)
Select USB-OEM