Important Notes On The Bumblebee Tablet Pc - Berkeley Varitronics Systems BumbleBee-TABLET Manual

In order to eliminate known sources of interference with the BumbleBee Tablet Receiver, please
•
ensure that the Wireless LAN Radio and the Bluetooth transmitter are disabled before using the
software.
• The Software, along with the Billionton CF Card Drivers are installed on the Tablet at the
following location: C:\ProgramFiles\BVS\BumbleBee Tablet Edition.
• If there is ever any problem in getting the software to talk to the BumbleBee Receiver, please
uninstall and re-install the Billionton CF Card Drivers.
• Before replaying of a Previously logged spectrum file begins, if the software is talking to the
receiver, the software will terminate the connection to the Receiver through the CF Card. In
order to begin active spectrum analysis again, the connection will have to be re-established as
discussed in the manual.
When the BumbleBee receiver is being used with Batteries, the software will monitor the battery
•
charge and will terminate the application if the batteries drop low on charge. A notification
message will be displayed before the software terminates. This is done to protect the batteries
from draining completely.
• The CF Card must be securely connected to the cable and the cable must be securely connected
to the BumbleBee Receiver through the round connector. Loose cable connection can be a major
problem while using the BumbleBee Tablet Software.
• Please remove the CF card from the CF Card slot on the BumbleBee Tablet before replacing the
batteries on the BumbleBee Receiver.
• Use Fully charged batteries in the BumbleBee Receiver and charge the BumbleBee Tablet before
running the software for a longer duration of usage. When the batteries in the BumbleBee
Receiver fall low on charge and need to be recharged, the BumbleBee Tablet software will shut
down after a 30 second warning message.
• When using the BumbleBee with an external power supply, ensure that the Green power
indicator LED turns on when the power supply is connected.
• The default power settings cause the Tablet PC to turn off and hibernate after 15 minutes.
For better performance, set the Tablet PC power options to optimize performance. This can be
done by: Start Menu>>Control Panel>>Power Options.
IMPORTANT NOTES
35