Set Linear Correction; Enter Parameter Setttings Mode - Powermatic WP2510 Operating Instructions And Parts Manual

9. Set Linear Correction

NOTE: Setting Linear Correction should be done in MM (metric) mode, not inches. This will ensure
accurate readings for table movement.
Step 1: Press
Display
Step 2: Enter the value between 0.0001 and 9.9999
Step 3: Press

10. Enter Parameter Setttings Mode

With this function, you can select each parameter to be locked or unlocked. When a
parameter is locked, then the end-user can only see the value, but can not change it.
Step 1: Press
Display
Step 2: Enter the password.
Step 3: Use
Step 4: Press
On = unlock
Off = lock
Step 5: Press
to confirm or press
to scroll through the parameters.
to lock or unlock.
to confirm or press
29
to clear.
to clear.