Powermatic WP2510 Operating Instructions And Parts Manual page 22

SINGLE MODE
In single mode, the device performs automatic positioning of the table to the
programmed target position. The "Table Up" or "Table Down" button on the planer
should be pushed and held; when the table has fully adjusted to the target position, the
table will automatically stop in position. Release the push button.
Setting Target Value
Step 1: Press (Target window LED starts blinking)
Step 2: Enter the target value using numerical keypad.
Step 3: Press to complete.
LED lamp starts blinking – the device is ready to start the positioning.
Start/Stop/Cancel
Press to start the positioning. The LED lamp now stops blinking and remains
on during the procedure.
Press to cancel the positioning. The LED lamp is turned off.
If the key is pressed while the positioning is running, the procedure is
interrupted, the machine is stopped, and the LED is turned off. To repeat the
positioning of the same target, press .
To program another target value, press
- enter new value - .
22