Calibration; M15S Troubleshooting - Powermatic WP2510 Operating Instructions And Parts Manual

15. Calibration

Step 1: Press
Display
Step 2: Use
M15S terminates the calibration and restarts.

16. M15S Troubleshooting

Display
"Change RST" message appears when the Controller detects a motion in the wrong
direction. For example, the Controller switches the outputs to move upward but the
table starts moving in the reverse direction. Usually this is caused by the wrong wiring of
the three phase motor.
Press to clear.
Check the wiring and change if necessary.
to move the planer table until
33