Honda FIT 2014 Owner's Manual page 271

12/04/18 15:03:39 42TF2C00_271
Lights
TAB
BULB HOLD-DOWN WIRE
Unclip the end of the hold-down
4.
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.
266
Maintenance
HOLD-DOWN WIRE
SLOT
Install the new bulb into the hole,
5.
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
6. Make sure that the hold-down
wire is installed properly and
securely. You can check its
installation from the inspection
window on the headlight assembly.
7. Install the rubber weather seal
over the back of the headlight
assembly. Make sure it is right
side up.
8. Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.