Chapter 8. Operation; Operating Procedures; Control Stations; Emergency Stopping - Snorkel MHP 15J Operator's Manual

Hide thumbs Also See for MHP 15J:
Table of Contents

Advertisement

Operating Procedures

This chapter explains how to properly start and op-
erate an MHP15J. Read and understand all the
previous chapters in this manual before you begin
to operate an MHP15J.
CAUTION
If you use the MHP15J for painting be sure
the optional sandblast protection kit is
installed to protect the hydraulic cylinder
rods from paint. Do not leave the MHP15J
engine running if you are sandblasting.
Sand drawn into the air intake can erode
engine parts.

Control Stations

An MHP15J can be operated from the ground con-
trol box or from the platform control box. There are
basically two differences between ground control
and platform control operations, both are safety re-
lated:
1. The ground control box can override the
platform control box at any time. If a person
operating the machine from the platform
becomes incapacitated, a person on the
ground can always take over machine control.
2. The stabilisers can only be selected from the
ground control box and only when the
booms are in the stowed position.
DANGER
The MHP15J is not Electrically Insulated.
Death or Serious Injury to operating
personnel, can occur if the machine should
come into contact with energized electrical
wires during operation.
DO NOT attempt to operate the MHP15J
ground controls if the platform, booms, or
any other conducting part of an MHP15J is in
contact with energized electrical wires or if
there is an immediate danger of such
contact.
NOTE
See the "Electrical Hazard" section, in this
manual for a complete explanation of the hazards
concerning electricity.

Emergency Stopping

To stop an MHP15J, press the Emergency Stop
s w i t c h c o v e r d o w n o n e i t h e r o f t h e t w o
EMERGENCY STOP switches at the ground con-
trol box or at the platform control box.
MHP15J – 11995A

Chapter 8. Operation

Figure 8.1 - Ground Control Box Emergency
Stop Switch Location.
Figure 8.2 - Platform Control Box Emergency
Stop Switch Location.
NOTE
For a complete discussion of the Emergency
Stop switches, see "Controls" chapter 6, in this
manual.

Operation Considerations

To use this chapter, first decide whether you will be
starting and operating the MHP15J from the
ground control box or the platform control box.
page 8 - 1

Advertisement

Table of Contents
loading

Table of Contents