Table of Contents
Advertisement
Chapter 7. Pre-operational Inspection
Figure 7.9 - Hydraulic Oil Leaks
Hydraulic oil leaks are easily visible and can show
up anyplace.
Visually inspect the entire machine for hydraulic oil.
Check the ground under the machine for leaked oil.
Carefully inspect the ends of the upper and lower
booms. Oil can run down inside of the booms and
drip out the end.
Bolts and Fasteners
Visually inspect all fasteners to see that none is
missing or obviously loose.
Figure 7.10 - Critical Pin Retainer Bolts
Critical pin retainer bolts have lock tab washers fit-
ted, they should all be present and not damaged in
any way.
Figure 7.11 - Wheel Nuts
page 7 - 4
Pay particular attention to all of the wheel nuts and
bolts.
None should be visibly loose, missing, or de-
formed.
Wheels and Tyres
The MHP15J relies on it's tyres for towing stability.
Figure 7.12 - Tyre Condition
Check each wheel for obvious damage that could
cause a blowout.
Figure 7.13 - Tyre Pressure
Ensure tyre pressures are maintained according to
the decal attached to the mudguard (fender).
Structural Damage and Welds
Visually inspect all welds for cracks, all structural
members for deformity.
MHP15J – 11995A
Advertisement
Table of Contents
