Table of Contents
Advertisement
Safety Device Information
For emergency operation controls and procedures,
see the "Emergency Operation" chapter 9, in this
manual.
The devices listed in this chapter are safety de-
vices.
They are on the MHP15J to increase safety in the
work place for both the operator and other people
near the MHP15J.
CAUTION
DO NOT by pass, disable, modify, or ignore
any of these devices. Check them carefully
at the start of each work shift to see that they
are in working order (see "Pre-operational
Inspection" chapter 7). If any is found to be
defective, remove the MHP15J from service
immediately until a qualified service
technician can make repairs.
Emergency Stop Switches
At ground control box
Figure 2.1 - Emergency Stop Switch at
Ground Control Box
Press the EMERGENCY STOP switch cover down,
at any time, under any conditions and the entire
machine stops, and nothing moves. This emer-
gency stop switch cover must be up and the switch
turned on for anything on the MHP15J to work.
MHP15J – 11995A
Chapter 2. Safety Devices
At platform control box
Figure 2.2 - Emergency Stop Switch at
Platform Control Box
Press the EMERGENCY STOP switch cover down,
at any time, under any conditions and the entire
machine stops, and nothing moves. This emer-
gency stop switch cover must be up and the switch
turned on for anything on the MHP15J to work.
NOTE:
The ground control box is designed to override
the platform control box. If the platform control
box EMERGENCY STOP switch is down (off) the
ground control box can still be used to start and
operate the MHP15J.
Other Safety Devices
Lanyard anchor points
Figure 2.3 - Lanyard Anchor Points
page 2 - 1
Advertisement
Table of Contents
