Subscribe to Our Youtube Channel
Related Manuals for Invacare LBEF
Summary of Contents for Invacare LBEF
- Page 1 ADJUSTABLE LEISURE BED Economy Models: LBET, LBEF and LBEQ Deluxe Models: LDBT, LBDF and LBDQ OWNER'S ASSEMBLY AND OPERATING MANUAL...
-
Page 2: Special Notes
SPECIAL NOTES WARNING DO NOT OPERATE THIS EQUIPMENT WITHOUT FIRST READING AND UNDERSTANDING THIS MANUAL. IF YOU ARE UNABLE TO UNDERSTAND THE WARNINGS, CAUTIONS, AND INSTRUCTIONS, CONTACT A HEALTHCARE PROFESSIONAL, DEALER OR TECHNICAL PERSONNEL IF APPLICABLE BEFORE ATTEMPTING TO USE THIS EQUIPMENT - OTHERWISE INJURY OR DAMAGE MAY RESULT. -
Page 3: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS SPECIAL NOTES ..........................2 SAFETY SUMMARY ..........................4 SPECIFICATIONS ..........................5 ASSEMBLY ............................6 Preparation ............................6 Installing Locking Casters ........................6 Installing Mattress Retainer Bar .......................6 Connecting Pendant ........................6 Installing Mattress ..........................6 Installing a Head Board ........................6 Removing Adjustable Head Board Brackets ..................6 OPERATING ............................8 Operating Bed ..........................8 Locking/Unlocking Casters ......................8... -
Page 4: Safety Summary
SAFETY SUMMARY SAFETY SUMMARY WARNING OPERATING INFORMATION After bed has been assembled, always test to make sure that all sections of the bed are properly and securely in place BEFORE using. Keep ALL moving parts free of obstruction (i.e. blankets/sheets, heating blankets/pads, tubing, wiring, etc. -
Page 5: Specifications
DO NOT open assemblies such as the motors, pendant, junction boxes or electrical control boxes. ONLY trained service personnel certified by Invacare are qualified to repair these parts. If uncertified individuals perform any work on these beds, the warranty is voided. -
Page 6: Assembly
ASSEMBLY ASSEMBLY ASSEMBLY (FIGURE 1) 3. Install the four (4) washers and wing nuts onto the four (4) threaded studs and tighten securely. Preparation Connecting Pendant 1. Remove the following from the bottom of the bed: NOTE: This procedure is for economy model beds only. A. - Page 7 ASSEMBLY Removing Adjustable Head Board Bracket 1. Remove the mounting screws and wing nuts that se- cure adjustable head board bracket to bed frame. 2. Remove adjustable head board bracket from bed frame. NOTE: Save head board brackets for future use. Locking Casters (In Plastic Bag) Lift Tube Assembly HEAD...
-
Page 8: Operating
OPERATING OPERATING OPERATING BED Press and Hold to Press and Hold to Raise Foot Raise Head WARNING Lower Foot Lower Head DO NOT lay, sit or lean in such a way that Press to Return entire body weight is placed on the head Press to to Flat Position or foot end of the bed while raising or low-... -
Page 9: Mattress
OPERATING 3. With one (1) person holding the head/foot end of the Locking Caster bed UP, remove the clevis and hitch pin that secure the motor to the bed frame. Locking Lever 4. Set the drive shaft of the motor on the floor. 5. -
Page 10: Troubleshooting
No Head/Foot functions (No UP or Head/Foot already in highest position. Lower head/foot. DOWN), other functions work. Bad Motor. Contact Invacare, 1-800-832-4707. Bad pendant. Contact Invacare, 1-800-832-4707. Excessive massage noise. Bed is in the level position. Raise head and foot ends slightly (ap- NOTE: Because of the function of proximately 1/2-inch). -
Page 11: Frequency Channel/Battery
FREQUENCY CHANNEL/BATTERY FREQUENCY CHANNEL/BATTERY CHANGING FREQUENCY CHANNEL REPLACING BATTERY (FIGURE 2) (FIGURE 1) NOTE: This procedure is for deluxe model beds only. NOTE: This procedure is for deluxe model beds only. NOTE: Deluxe Model Pendants require one (1) 12V bat- tery. - Page 12 INVACARE CORPORATION l ONE INVACARE WAY l Elyria, OH 44035 l Customer Service (800) 333-6900 l Technical Support (800) 832-4707 Form No. 98-317 P/N 1085400 Rev. (1) -2/99 Printed in USA...
Need help?
Do you have a question about the LBEF and is the answer not in the manual?
Questions and answers