Canon iR 3250 Network Manual page 27

G Using BOOTP
Press the [Enable BOOTP]. Enter the
IP Address, Subnet Mask, and
Gateway Address. (If this information
cannot be obtained by the BOOTP, the
settings entered from the control panel
are used.)
6
Enter the DNS Server.
If you are using a DNS server, press the [DNS Server] key and enter the address of the
DNS server.
7
Enter the Host Name and Domain Name.
For the Host Name, press the [Host Name] key and enter the name of your machine. For
the Domain Name, press the [Domain Name] key and enter the domain name of the
network to which your machine belongs. Each name can be up to 47 characters in length.
G Example
Host name: host_name
Domain name: organization.company.com
8
Confirm the settings you entered, and press the [OK] key.
The display returns to the Network Settings screen.
9
Press the [Done] key.
Repeat until the Additional Functions screen closes.
10
Restart the machine.
Turn the printer unit power switch, the scanner unit power switch, and the control panel
power switch to OFF, and then turn the power to ON after waiting at least 3 seconds.
NOTE
• If you are entering additional e-mail/I-fax settings, you do not need to restart the machine at this
point. Finish entering the e-mail/I-fax settings, and then restart the machine.
The settings are now complete.
2-10 Protocol Settings