Certification; Spare Parts; Service And Repair - Honeywell HERMetic UTImeter Gtex Chem Operation And Service Manual

3.5 Certification

Enraf Tanksystem SA is an
ISO 9001 and MED-D certified company
by Det Norske Veritas
Certification GmbH.
The equipment has been approved for the electrical intrinsic
safety by the following authorities :
IECEx
Zone 0 Ex ia IIB T4 -20°C < Ta < +50°C
Standards used:
IEC 60079-0, Fourth Edition 2004-01,
IEC 60079-11, Fifth edition 2006-07
IEC 60079-26, First edition 2004-03
ATEX
II 1 G EEx ia IIB T4 / Tamb. 50 °C
Standards used:
EN50014, (1997) + Amds 1 & 2
EN50020, (2002)
EN50284, (1999)
Regarding product compliance against standards updates or
new standards, please refer to the Declaration of conformity.
Factory Mutual (FM Approvals)
CL I, DIV 1, GP C&D, T4 Tamb. 50 °C and
CL I, ZN 0, AEx ia IIB T4 Tamb. 50 °C
The equipment has been approved as oil/water interface
detector according to MARPOL Resolution MEPC.5(XIII)
of 13 June 1980 by National Maritime Authorities and/or
Classification Societies.
If you need a copy of any of these certificates please
contact:
Enraf Tanksystem SA
Rue de l'industrie 2
1630 Bulle, SWITZERLAND
Telephone : +41-26-91 91 500
Telefax : +41-26-91 91 505
Web site : www.tanksystem.com
E-mail : tanksystem@honeywell.com

3.6 Spare parts

When ordering spares identify the spare part by TS number and
description. Refer to section "Drawings".
Some spares might be repairable; in this case send the part(s)
to any authorised service center or to the factory.
In case of urgency, complete replacement units can be made
available. Contact the factory or nearest Service Station for
details.

3.7 Service and Repair

The customer is responsible for any freight and customs
clearance charges. If units are sent on a "freight collect" the
charges will be invoiced to the customer.
When returning units or parts for repair to the factory please fill
out a service request form (see next page). The serial number
(letter "G" followed by 5 digits) is printed on the identification
plate as shown on the Figure 2-1.
When returned to Enraf Tanksystem SA equipment
must be contamination-free. If it is determined that
the customers equipment is contaminated, it will be
returned to the customer at the customers expense.
Contaminated equipment will not be repaired until
such time that the customer decontaminates the said
equipment.
7