First Fire; Special Operator Note; Locating The Helifire 360 - Town & Country Fireplaces HELIFIRE 360 Installation And Operating Instructions Manual

Owners Information
When lit for the first time, the fire feature may emit a slight odor for a couple of hours. This is due to the curing
of paints, sealants and lubricants used in the manufacturing process. This condition is temporary. Open
doors and windows to ventilate area. Odors caused by the curing process may cause discomfort to some
individuals. It is normal for fireplaces fabricated of steel to give off some expansion and/or contraction noises
during the start up or cool down cycle. Similar noises are heard from your furnace, heat exchanger or cook
stove oven.
In planning for the
installation of the
HeliFire 360, it is
necessary to deter-
mine where the unit
is to be installed,
location of vent sys-
tem and where gas
supply piping may
be plumbed. Various
types of installations
are possible, such
as, a peninsula wall,
island, and between
two interior walls.
5055.64-a

Special Operator Note

NOTE: Fire feature may
take up to 30 seconds
to ignite each time the
"ON" button has been
selected

Locating the HeliFire 360

INSULATION
Figure 3: Locating the HeliFire 360.

First Fire

8
TCHF.22bodya_ 090617-36
TCHF.22STbodya