Lighting Instructions; First Fire - Town & Country Fireplaces C Series Installation And Operating Instructions Manual

WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which auto-
matically lights the pilot. Do not try to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
- Do not try to light any appliance.
1. STOP! Read the safety information above on this label.
2. Set wall switch/ hand held remote to lowest setting.
3. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by
hand.
4. Push the "On/ Off" switch to the fireplace Off.
5. Allow sufficient length of time (minimum 5 minutes) for any
gas in the combustion chamber to escape. If you still smell
gas, STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
1. Set wall switch / hand held remote to lowest setting.
2. Push the "on/ off" switch to the "Off" position.
Due to high surface temperatures, keep children, clothing and furniture away. Keep burner and control compartment
clean. See installation and operating instructions accompanying the appliance.
A cause de la temperature elevee des parios, tenir eloignes les enfants, les vetements et les meubles. Maintenir propres le
bruleur et le compartiment de commande. Voir les instructions relatives a l'installation et au fonctionnement qui accompagnent
l'appareil.
CAUTION :
furniture, gasoline and other liquids having flammable vapours away. Keep burner and control compartment
clean. See installation and operating instructions accompanying the appliance.
ATTENTION :
brûlures graves. Serveiller les enfants. Garder les vêtements, le meubles, l'essence ou autres liquides
produisant des vapeurs inflammables loin de l'appareil. S'assurer que le brûleur et le compartiment des
commandes sont propres. Voir les instructions d'installation et d'utilisation qui accompagnent l'appareil.
310106
TC30_CE3 011012-44

Lighting Instructions

FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
Hot while in operation. Do not touch. Severe burns may result. Keep children, clothing,
L'appareil est chaud lorsqu'il fonctionne. Ne pas toucher l'appareil. Risque de

First Fire

When lit for the fi rst time, the fi replace will emit a slight odour for a couple of hours. This is
due to the curing of paints, sealants and lubricants used in the manufacturing process. This
condition is temporary. Open doors and windows to ventilate area. Odour caused by the
curing process may cause discomfort to some individuals.
It is normal for fi replaces fabricated of steel to give off some expansion and/or contraction
noises during the start up or cool down cycle. Similar noises are found with your furnace
heat exchanger or cook stove oven.
29
- Do not touch any electric switch; do not use any phone in your
building.
- Immediately call your gas supplier from a neighbour's phone.
Follow the gas supplier's instructions.
- If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never
use tools. If the knob will not push in or turn by hand, don't try
to repair it, call a qualified service technician. Force or at-
tempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance & to replace any part of the control system & any gas
control which has been under water.
6. Push the "On/ Off" switch to turn the fireplace on.
- If the burner does not light, repeat steps 4 through 6.
- If the burner will not light or stay lit after several
tries,push the "On/ Off" switch to the fireplace off and
call your service technician or gas supplier.
Note: Sufficient time must be allowed for air to escape
from lines if the unit is being lit for the first time.
7. Set fireplace to desired setting by using either the wall
switch or hand held remote.
3. Turn off all electric power to the appliance and remove
backup batteries if service is to be performed or for extended
shutdown.
5051.173 5-TC30