Installation - ACR Electronics AIS Link MOB User Manual

3.

INSTALLATION

NOTE: Be sure to load the activation tape EXACTLY as described in this section.
Failure to do so may affect deployment.
If your AISLink MOB is not already pre-installed into the life jacket, please carefully follow
the instructions below. The diagrams below assume that the life jacket inflation tube is on
the left hand side (as viewed). If the tube is on the right hand side, then the tape should
be fitted on the opposite sides shown. When reviewing this installation section, please note
that there are two bracket mount locations (an upper and lower location) which exist for
flexibility to vary the fit of the AISLink MOB. The upper location is the preferred mounting
position for most user fit scenarios.

Installing the activation tape: Take the oral mounting bracket or the installation
mounting bracket and pass the activation tape through the loop as shown below.

The activation tape must be
inserted into the activation slide.
You must remove the activation
slide from the MOB. Depress
either the left or right arming
retainer and push the slide either
right or left. The antenna will
deploy and the MOB will activate.
 To deactivate your MOB, press the "TEST/OFF" key until the LED flashes red twice,
then release.
 There is a front and rear section of the
activation slide. Place the rear of the activation
slide so that it sits over the activation tape and
then pass the activation tape through the slot in
the middle. As the tape is threaded through the
middle, ensure that the tape is positioned
between the small protrusions
of the two up stands on the
7
Up stands
MOB USER MANUAL
FRONT
Activation Slide
Y1-03-0283 Rev. C
REAR