ACR Electronics AIS Link MOB User Manual page 13

D2. Load the fixing buckle with the activation tape as shown below.
D3. Bond the fixing buckle to the fixing buckle patch. Ensure that the two ears of the 'T'
are positioned on the side of patch without the adhesive. This will ensure that when the
buckle is tensioned it cannot be pulled through the adhesive patch.
D4. Clip the MOB to the installation bracket and then adhere the fixing buckle patch
assembly to an appropriate position on the bladder in line with the activation slide.
D5. Follow the steps indicated previously in Section 3 to attach the activation tape to the
activation slide, rewind the antenna (section 6), and finally re-insert the activation slide
back in-between the two arming retainers. The product is now correctly installed on the
life jacket (see next image).
MOB USER MANUAL
13
Fixing Buckle and
Activation Tape
Assembly adhered to
bladder using the
Fixing Buckle Patch
Fixing Buckle Patch
Y1-03-0283 Rev. C