ACR Electronics AIS Link MOB User Manual page 15

4.2.1 Installation
The programming software for configuring the User MMSI
into the MOB can be downloaded from
by going to the AISLink MOB product page and clicking on
"Configure AISLink MOB". The software available will only
allow the DSC options available in your country. Some
functions described below may not be available to you. If
accessing the downloadable PC software, save the .ZIP file
to your Windows computer, open it, and click
Installer.msi to run the installer and install the software on
your computer.
There is also a web application which can be accessed by going to the AISLink MOB
product page and clicking on "Configure AISLink MOB". This web application can be run on
any computer or most modern smart phones and tablets using the web browser.
4.2.2 Configuration
Run the downloaded programming software application from the location where it was
saved on your Windows computer. The screen shown in 4.2.1 will appear. Please note
that the screenshots shown in this section will appear slightly different than shown when
using the web based programming software. Simply follow the on-screen instructions
when using the web based software.
Enter the nine digit MMSI of the vessel in the box provided.
(In the USA, after the MMSI has been entered, a second box for
a group MMSI will appear. Enter your group MMSI here if
applicable, noting that group MMSI numbers should always start
with a single zero. In the USA, leave the "Enable DSC Relay" box
checked in order to enable DSC functionality)
Press the Update Device button on screen.
A new screen with further instructions will appear.
To put the MOB into programming mode, press the "TEST/OFF" key for at least fifteen
seconds. The LED will start flashing green. Release the key. Fit the black rubber
Programming Adaptor so that the aperture is over the Strobe LED.
When ready, press the Continue button on screen.
The display will now change to the programming
mode. With the programming adaptor fitted, place
the MOB over the screen so that the aperture of the
programming adaptor is over the white box. Press
the <F10> key on your keyboard to commence
programming.
www.acrartex.com/
15
MOB USER MANUAL
Y1-03-0283 Rev. C