ACR Electronics AIS Link MOB User Manual page 11

B2. Load the fixing buckle with the activation tape as shown below.
B3. Bond the fixing buckle to the fixing buckle patch. Ensure that the two ears of the 'T'
are positioned on the side of the patch without the adhesive. This will ensure that when
the buckle is tensioned it cannot be pulled through the adhesive patch.
B4. Adhere the fixing buckle patch assembly to an appropriate
position on the bladder in line with the activation slide.
B5. Follow the steps indicated previously in Section 3 to
attach the activation tape to the activation slide, rewind
the antenna (section 6), and finally re-insert the
activation slide back in-between the two arming retainers.
NOTE: The reflective patches are not intended for long
term external exposure. Patches will need inspecting and
possible replacement following a deployment.
C. Installation bracket attachment onto jacket with separate bladder:
C1. Thread a reflective strip, with the protective backing removed, through the slots on
the installation bracket. Attach the bracket to the product and position in the desired
location on the bladder. Be sure to press down on the reflective strip in order to
adhere it securely to the bladder. Now remove the product from the bracket and
MOB USER MANUAL
11 Y1-03-0283 Rev. C