ACR Electronics AIS Link MOB User Manual page 12

attach the second reflective strip at 90 degrees to the first. Be sure to once again
press down on this second reflective strip in order to adhere it securely to the bladder.
Pass the activation tape around
C2.
the bladder of the life jacket and
then clip the MOB to the
installation bracket.
C3. Follow the steps indicated
previously in Section 3 to attach
the activation tape to the
activation slide, rewind the
antenna (section 6), and finally re-
insert the activation slide back in-
between the two arming retainers.
D. Installation bracket attachment onto jacket with bladder stitched into cover:
D1. Thread a reflective strip, with the protective backing removed, through the slots on
the installation bracket. Attach the bracket to the product and position in the desired
location on the bladder. Be sure to press down on the reflective strip in order to adhere it
securely to the bladder. Now remove the product from the bracket and attach the second
reflective strip at 90 degrees to the first. Be sure to once again press down on this second
reflective strip in order to adhere it securely to the bladder.
MOB USER MANUAL
12 Y1-03-0283 Rev. C