Table of Contents
Advertisement
en | 2 6 | User guide | HDS 200 HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles
Select Module
J1587 Modules
Engine #1
Transmission
Brakes, Power Unit
J1939 Modules
Engine #1
Transmission #1
J1587 MID: 128 Engine #1
3.
View information supported by vehicle.
•
Use the
UP and
In this example, the Brake, Power Unit module returned
data.
Module Information
Make
**BNDWS
Model
EC-30 JI
Serial Number
F43080
Software ID
BW-362-CD R07
Brakes, Power Unit
In this example, the Engine #1 module returned data.
Use the
UP and
DOWN keys to view all the infor-
mation.
Module Information
Make
INT
Model
390224241011696M10
EXEMPT
Serial Number
6.5HM2Y5303951
VIN
1HTJTSKL6BH449799
Engine #1
Module Information
Serial Number
6.5HM2Y5303951
VIN
1HTJTSKL6BH449799
Calibration Information
CVN
Calibration ID
67820293
Software ID
PRS29XR5
Engine #1
4.
Return to Module Information menu.
•
Press
.
5.
Return to Heavy Duty Standard menu.
•
Press
.
5.6
Vehicle Information
The Vehicle Information function allows the scan tool to
request information from the Engine module(s) on the
581618 | REV. A | 11.2017
DOWN keys (if required).
CARB ESS
*
*
vehicle. Information collected includes Total Vehicle
Distance, Total Vehicle Hours, & VIN.
The scan tool cannot verify if data is correct for scanned
modules.
From Heavy Duty Standard menu:
1.
Select Vehicle Information.
•
Use the
UP and
Information is highlighted.
•
Press
.
Heavy Duty Standard
Read Codes
Erase Codes
View Data
Record Data
Module Information
Vehicle Information
Review Data
Print Data
System Setup
2.
View information supported by vehicle.
Vehicle Information
VIN
3FRWF6FC4BV629240
Total Distance
144983 Miles/233328 km
Total Time (h:mm)
2414:00
3.
Return to Heavy Duty Standard menu.
•
Press
.
6
OBD II Diagnostics
OBDII Diagnostics is available by selecting HD OBD (ISO
15765-4) or Global Automotive OBDII from the Main
Menu.
This section applies to all Global OBD II compliant vehi-
cles. The first time the scan tool links to the vehicle, the
communication protocol is automatically detected, and
is used until the scan tool is turned off or another vehi-
cle is diagnosed.
If an error message displays, make sure the OBD II
connector is attached and the ignition key is on. Cycle
ignition key to OFF for 10 seconds, then ON. This may be
required to reset computer. If required, select YES to try
again. If problem still exists, refer to "7.1 Error Mes-
sages" on page 41.
The scan tool keeps data received from the previous
vehicle selected until any of the following occurs:
•
A new vehicle is selected.
•
Scan tool is flash programmed to update software.
On initial link to vehicle, scan tool checks the status of
I/M Monitors no matter which function is selected.
DOWN keys until Vehicle
Bosch Automotive Service Solutions Inc.
Advertisement
Table of Contents
