State OBD Check
MIL Status
Codes Found
Monitors OK
Monitors Inc
Monitors N/A
3.
Return to HD OBD menu or Global Automotive
OBDII menu.
•
Press
.
6.6
View Data
The View Data function allows real time viewing of the
vehicle's computer module's parameter identification
(PID) data. As the computer monitors the vehicle, infor-
mation is simultaneously transmitted to scan tool.
View Data allows the following items to be viewed on
the scan tool:
•
Sensor data
•
Operation of switches
•
Operation of solenoids
•
Operation of relays
View Data can be shown as:
•
Entire Data List
•
Custom Data List
Apart from Read Codes, View Data is the most useful
diagnostic function for isolating the cause of a vehicle
operation problem.
From HD OBD menu or Global Automotive OBDII menu:
1.
Select View Data.
•
Use the
UP and
Data is highlighted.
•
Press
.
Global Automotive OBDII
I/M Monitors
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
2.
Observe while the scan tool validates PID MAP.
•
PID MAP validation is the tool asking the vehicle
which PIDs are supported. Refer to "8
Appendix A—Global OBD II PID Definitions" on
page 42 for a complete list of PIDs supported
by the tool.
•
Multiple PIDs may be sent if vehicle is equipped
with more than one computer module (for
example a powertrain control module [PCM]
and a transmission control module [TCM]). The
Bosch Automotive Service Solutions Inc.
HDS 200 HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles | User guide | 31 | en
OFF
0
3
4
4
DOWN keys until View
scan tool identifies them by their identification
names (ID) assigned by manufacturer (i.e. $10
or $1A).
•
If one or more control module stops responding,
the scan tool displays a message.
–
If continuing, dashes will replace data in
right-hand column.
–
If NO is selected, then the scan tool
attempts to re-establish communication
with that module.
Validating PIDs
Waiting for vehicle to
respond
Please Wait
Validating PIDs
Validating PID List
PID 19/329
Please Wait
View Entire List
View Entire List shows all supported PID data for the
vehicle being tested.
From Select Data to View menu:
1.
Select Entire Data List.
•
Use the
UP and
Data List is highlighted.
•
Press
.
Select Data to View
Entire Data List
Custom Data List
English/Metric
2.
View PIDs on scan tool.
•
Use the
UP and
•
Refer to "8
Appendix A—Global OBD II PID
Definitions" on page 42.
DOWN keys until Entire
DOWN keys.
581618 | REV. A | 11.2017