Body Solid G6B25YR Owner's Manual page 37

S T E P
14
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Leave all pulley bolts hand tight until step 15
A. Bolt Pec Dec Cable (88) to Left Pec Dec Cam (P) as shown in diagram 1 using:
One 50 (3/8" x 1" hex head bolt)
One 71 (3/8" nylon lock nut)
Two 78 (3/8" washer x 3/4" O.D)
B. See diagram 1. Route Cable (88) through Pulley Swivel (AC) on the left side, hold cable in place
with Pulley (C1) using:
One 51 (3/8" x 1 3/4" hex head bolt)
Two 74 (3/8" washer)
One 71 (3/8" nylon lock nut)
C. See diagram 1. Route Cable (88) up and into 90 Degree Double Pulley Holder (CC) and install
Pulley (C2) using:
One 51 (3/8" x 1 3/4" hex head bolt)
Two 74 (3/8" washer)
One 71 (3/8" nylon lock nut)
B. Insert Cable (88) through Pulley Swivel (AC) on the right side, hold cable in place by installing
Pulley (C3) as shown in diagram 2 using:
One 51 (3/8" x 1 3/4" hex head bolt)
Two 74 (3/8" washer)
One 71 (3/8" nylon lock nut)
C. Attach Cable (88) to Right Pec Dec Cam (S) as shown in diagram 1 using:
One 50 (3/8" x 1" hex head bolt)
One 71 (3/8" nylon lock nut)
Two 78 (3/8" washer x 3/4" O.D)
mm
Inch
Pec Dec Cable (88)
Stamped Eye End
2055 mm
Stamped Eye End
6' 9"
36