Overall System Topology - Cisco SCE 8000 Installation Manual

Install the Cisco SCA BB application component (PQI file) and protocol pack on the Cisco SCE platform (see the
Step 5
"Installing the Application on the Cisco SCE Platform" section on page
Step 6 Perform additional initial configuration, if any, of the Cisco SCE 8000 platform from the management workstation (see
the "Initial Configuration of the Cisco SCE 8000 Platform" section on page
Perform initial configuration of the Cisco SCA BB application by using the Usage Analysis wizard (see the
Step 7
SCA BB Configuration" section on page
2
Cisco Service Control Solution Topology
This section describes the possible deployment topologies of the Cisco Service Control solution.
This section presents the deployment topologies for the Cisco SCE 8000 platform.
Note

Overall System Topology

Figure 2 illustrates the general topology of the Cisco Service Control solution.
• Horizontal flow—Represents traffic between subscribers and an IP network.
The SCE platform monitors traffic flow.
• Vertical flow—Represents transmission of RDRs from the Cisco SCE platform to the SCMS Collection Manager.
The SCMS Subscriber Manager provides subscriber data. This flow allows Cisco SCA BB to conduct subscriber-level
analysis and control.
Figure 2 Flow of Information in SCA BB
Broadband
subscribers
Aggregation
device
(CMTS,BRAS,
switch, etc.)
32).
RADIUS/DHCP
Login/Logout
Router/
Switch
PWR A PWR B STATUS
MNG 1 BYPASS Cisco SCE
MNG 2 2000
CONSOLE AUX LINK RX Series
LINK/ ACTIVE 1000 10/100/ LINK/ 10/100/ TX LINK RX 4xGB E
ACTIVE 1000 TX
LINK RX TX
RX LINK RX TX
MM TX RX
MM TX
RX MM TX
GBE-1 RX MM TX
SUB
LINE NET
SUB LINE/CASCA GBE-2
DE NET
20).
Service Control
Subscriber Manager
Subscriber
provisioning
Router/
Switch
Usage information
and statistics
Service Control
Collection Manager
31).
Internet
"Initial Cisco
5