Cisco SCE 8000 Installation Manual page 14

Step 4 (Optional) Edit the install-def.cfg file.
Note We recommend that you edit the install-def.cfg file if you do not want the default parameter values to be used.
The install-def.cfg file contains several parameters that can be configured before you install the Subscriber Manager.
The installation routine copies these parameters to the relevant Subscriber Manager configuration file. By default, all
the parameters are commented and the default values are used.
Table 6 lists the parameters of the install-def.cfg file.
Table 6 Parameters of the install-def.cfg File
Parameter Name
max_subscribers_num SM definitions
sm_memory_size
database_perm_size
database_temp_size
Execute the install-sm.sh script.
Step 5
You can customize the install-sm.sh script.
Note
If the /etc/motd file exists, it is not possible to run the script. Move or remove the /etc/motd file before you run
Note
the install-sm.sh script.
From your workstation shell prompt, move to the directory to which the distribution file was extracted and run the
install-sm.sh script. See the "Installation Procedure" section of the "Installation and Upgrading" chapter of Cisco
Service Control Management Suite Subscriber Manager User Guide.
Set the password for the pcube user.
Step 6
After the installation script runs successfully, set the password for the pcube user by running the # passwd pcube
command.
We recommend that you note down this password for future use.
Note
Reboot the computer. This step is mandatory to complete the installation.
Step 7
14
Resides In Description
Defines the maximum number of
subscribers that the Subscriber Manager
supports.
Maximum:
• Linux—2 million
Default is 200,000.
SM definitions Defines the amount of memory, in
megabytes, that is allocated for the
Subscriber Manager process.
Database Defines the PermSize, in megabytes,
definitions allocated for the database.
Database Defines the TempSize, in megabytes,
definitions allocated for the database.
Alternate Configuration Option
The max_number_of_subscribers
parameter in the p3sm.cfg
configuration file.
The PCUBE_SM_MEM_SIZE in the
sm.sh file that resides in the ~pcube
folder.
The PermSize parameter in the
/var/TimesTen/sys.odbc.ini file.
The TempSize parameter in the
/var/TimesTen/sys.odbc.ini file.