Huawei IPC6122-P Configuration Manual page 21

IPC6122-P
Configuration Guide
Figure 3-4 ONVIF parameters
Table 3-4 ONVIF settings
Parameter
To Enable ONVIF
Parameters
To Change the ONVIF
Password
To Configure the
ONVIF Media Stream
Issue 02 (2016-04-06)
Description
Select Enable ONVIF in Second Protocol Type.
NOTE
Change the ONVIF password to ensure security.
When the IPC uses the ONVIF protocol to connect to the video
surveillance platform, you must enter this password. Otherwise, the
connection cannot be set up. If platform authentication fails for
consecutively 10 times, the IPC is locked for 5 minutes. After you
change the password, keep the changed password safe.
1. In the Second Protocol Password management area, enter
passwords in the Old password, New password, and
Confirm password fields.
NOTE
The default user name is admin, and the default password is
HuaWei123.
To improve security, the password must consist of 8 to 20 characters
and contain at least two types of the following: uppercase,
lowercase, digits, and special characters.
2. Click Save.
NOTE
l Select a proper stream type based on the decoder requirements. For
example, when eSpace DEC6001-E is used to decode video streams,
you must select elementary stream.
l The ONVIF media stream can be configured only when the IPC is
connected to the video surveillance platform through the ONVIF
protocol.
Select a media transmission type from the Stream transmission
type drop-down list box.
l Elementary stream: uses the ES compression mode.
l Program stream: uses the PS compression mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Setting Basic Parameters
16