Cobalt Digital Inc BBG-1090-DEC-MPEG Product Manual page 9

Important Safety Information! Please note the following:
1. The BBG-1090-DEC-MPEG is intended for indoor use only.
2. In case of emergency, disconnect the power cords.
3. If power cords are not provided:
• In the United States, use standard computer power cords (as
specified below).
• In Europe, for 230 volt operation, use a cord set marked "HAR"
and consisting of a min 3 core H05VVF3G075 cord that has a
minimum 0.75 square mm diameter conductors, provided with
an IEC 320 receptacle and a male plug for the country of
installation, rated 6A, 250V.
4. Do not block the equipment vents.
READ THE FOLLOWING SAFETY INFORMATION THOROUGHLY BEFORE
INSTALLING THIS PRODUCT. FAILURE TO FOLLOW THIS SAFETY INFORMATION
MAY LEAD TO PERSONAL INJURY OR DAMAGE TO THE EQUIPMENT.
Power Supply
• This unit must be grounded.
• The unit must be connected to a grounded outlet to comply with product safety standards.
• The grounded socket-outlet shall be installed near the equipment and shall be easily
accessible.
• Do not connect the power supply unit to an AC outlet without a ground connection.
• All power cords must be disconnected before servicing.
Power Cords
The plug on the power supply cords is considered to be the equipment disconnect device and
must be approved for the country where it is used.
For USA and Canada:
• The cord set must be UL-approved and CSA-certified.
• The attachment plug must be an earth-grounding type with a NEMA 5-15P (15A 125V)
plug and an EN60320/IEC320 receptacle.
9