Cobalt Digital Inc BBG-1090-DEC-MPEG Product Manual page 51

• Received Rate (b/s): indicates the measured rate in bits/second at the input of the
decoder. This does not include FEC bit rate or UDP/IP overhead – it is the transport
stream rate.
• Protocol: indicates the detected protocol, either UDP or RTP.
• Current Source: indicates Primary or Backup.
• Stream Source IP Address: indicates the current IP address from which the stream is
being received.
• SMPTE 2022 FEC: Indicates the detected FEC mode, as follows:
o None: SMPTE 2022 FEC transmission is not being detected by the BBG-1090-
DEC-MPEG.
o Column Only: The BBG-1090-DEC-MPEG is detecting SMPTE 2022 FEC in
Column Only mode.
o Row and Column: The BBG-1090-DEC-MPEG is detecting SMPTE 2022 FEC
in Row and Column mode.
o Not Licensed: The SMPTE 2022 functionality is not licensed in this unit (see the
Admin License Keys Tab). If SMPTE 2022 FEC is present, it is being ignored by
the BBG-1090-DEC-MPEG.
• Columns: If SMPTE 2022 FEC is being received, this indicates the number of columns
detected.
• Rows: If SMPTE 2022 FEC is being received, this indicates the number of rows detected.
• Received Packets: Indicates the number of packets received since the last time the
statistics were reset. This count does not include the FEC packets, if any.
• Lost Packets: Indicates the total number of lost packets since the last time the statistics
were reset. Note that the BBG-1090-DEC-MPEG can only detect lost packets if the
incoming protocol is RTP. It is not possible to detect lost packets with UDP as it lacks a
sequence number.
51