Thermal Sensor - Lenovo ThinkStation P320 Hardware Maintenance Manual

Figure 111. Installing the internal speaker
7. Connect the internal speaker cable to the internal speaker connector on the system board. See "Parts
on the system board" on page 11.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 139.

Thermal sensor

Attention: Before you replace any FRU, be sure to read and understand Chapter 1 "Read this first:
Important safety information" on page 1.
To replace the thermal sensor, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 69.
2. Remove the front bezel. See "Front bezel" on page 70.
3. Disconnect the thermal sensor cable from the thermal sensor connector on the system board. See
"Parts on the system board" on page 11.
4. From the inner side of the chassis, pivot the left retaining clip
thermal sensor. Push the clip outward to release it and then disengage the plastic holder from the
chassis. Pull the entire thermal sensor out of the chassis.
1
that secures the plastic holder of the
.
Chapter 8 Hardware removal and installation
127