Memory Module - Lenovo ThinkStation P320 Hardware Maintenance Manual

Figure 22. Removing the old coin-cell battery
4. Install a new coin-cell battery.
Figure 23. Installing a new coin-cell battery
5. Reinstall the computer cover and connect the cables. See "Completing the parts replacement" on page
139.
Note: When the computer is turned on for the first time after replacing the coin-cell battery, an error
message might be displayed. This is normal after replacing the coin-cell battery.
6. Turn on the computer and all attached devices.
7. Use the Setup Utility program to set the date, time, and any passwords. See "Using the Setup Utility
program" on page 39.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 139.

Memory module

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Your computer has four memory slots for installing or replacing DDR4 UDIMMs that provide up to a
maximum of 64 GB system memory.
When installing or replacing a memory module, use 4 GB, 8 GB, or 16 GB DDR4 UDIMMs in any combination
up to a maximum of 64 GB. Do not mix any combination of ECC UDIMMs and non-ECC UDIMMs into the
same computer.
Note: Always install the memory modules in the alphabetic order as shown.
.
Chapter 8 Hardware removal and installation
77