Figure 71. Installing the solid-state drive into the storage converter
3. Remove the 3.5-inch storage drive bracket out of the chassis.
4. To install the storage converter into the 3.5-inch storage drive bracket, flex the bracket and align pin
pin
2
, pin
3
, and pin
Figure 72. Installing the storage converter together with the solid-state drive into the storage drive bracket
5. Install the storage converter with the bracket into the desired storage drive bay. See "Primary hard disk
drive" on page 111 or "Secondary hard disk drive" on page 113.
6. Connect the signal cable and the power cable to the solid-state drive.
102
P320 Hardware Maintenance Manual
4
on the bracket with the corresponding holes in the storage converter.
1
,