Table of Contents
Advertisement
3 Components and Power Supply
To correctly insert the card, please follow these steps:
(1) Switch off the device and remove the cables, as described in section
(2) Remove the device from the workplace and place it in a stable, safe location where it can be easily accessed
and handled.
(3) Remove the screws from the side panel to be able to dismantle the flap that gives access to the expansion
cards. Please see
(4) Once the screws have been removed, slide the flap and lift it (making sure no grooves attach the flap to the top
panel). Place it in a safe location.
(5) Find the place where the xDSL expansion board needs to be located.
xDSL expansion board: Location
Fig. 22:
(6) Remove the lid that holds the back cover located on the rear panel.
Lid cover for xDSL
Fig. 23:
(7) Using a screwdriver, remove the expansion slot cover.
Removing the SLOT 3 cover
Fig. 24:
(8) Place the xDSL expansion card so that this firstly adjusts to the space on the device rear panel and sub-
sequently to the motherboard connection. This operation must be carried out carefully, without forcing any piece
or part of the device. Check that the board is clearly settled over the motherboard connector.
(9) Screw the board to the securing posts using two screws and their corresponding washers. Firmly tighten the
screws without damaging the board.
(10) Put the expansion slot cover back and screw it down.
Repositioning the SLOT 3 cover
Fig. 25:
(11) Rearrange the top panel flap and screw it into place using the screws. Please see
(12) Connect and switch on the device as explained in section
lems, switch off the device and make sure that the above steps have been carried out correctly. If the problem
persists, please contact your supplier.
(13) Connect a terminal to the console and check that the device detects the xDSL board.
14
Fig. 9
on page 8.
Disconnecting
on page 17.
Fig. 14
Connecting
on page 17. Should you detect any prob-
Alcatel-Lucent
on page 9.
OA58XX-NW Router
Advertisement
Table of Contents
