Table of Contents
Advertisement
3 Components and Power Supply
Inserting the AIC expansion card
Fig. 18:
(9) Screw the AIC board to the standoff posts using two screws and their corresponding washers. Firmly tighten the
screws without damaging the board.
Screwing down the AIC expansion card
Fig. 19:
(10) Reposition the expansion slot cover and screw it down
Reposition the SLOT 2 cover
Fig. 20:
(11) Replace the top panel flap and screw it into place using the screws. Please see
(12) Connect and switch on the device, as explained in section
lems, switch off the device and make sure that the above steps have been carried out correctly. If the problem
persists, please contact your supplier.
(13) Connect a terminal to the console and check that the device detects the AIC board:
**************************************************
**************************************************
**************************************************
BIOS CODE DUMP....................
BIOS DATA DUMP.....
End of BIOS dump
FLASH BIOS CODE VERSION: 02.01
Current date: Mar 27 2013, Wednesday
System Info:
PCB:0x128 GPPORCR:0x00280000 PVR:0x80212051 SVR:0x80EC0011
CLKs(KHz): CCB=393216 CPU0=786432 CPU1=786432 DDR(clk)=327680 LBUS=49152
Watchdog: Enabled
MMU Mode: Dynamic
ICache: ON; DCache: ON Write-Back; L2Cache: ON
Mem Info:
DRAM size: 512 Megabytes
BANK 0: 512 Megabytes (detected)
FLASH: 65024 KB.
NVRAM: 128 KB.
EEPROM: 2048 Bytes.
Devices:
12
Connecting
Mar
6 2013 17:59:56
L1
Current time: 12:56:57
Fig. 14
on page 9.
on page 17. Should you detect any prob-
Alcatel-Lucent
OA58XX-NW Router
Advertisement
Table of Contents
