Adjustment Of Spill Guard Link; Tire Inflation; Inflation Pressure - Kubota B26TL Operator's Manual

ADJUSTMENT OF SPILL GUARD LINK

To avoid personal injury:
A Keep your hand away from links or boom when
operating the loader.
1. Remove the cotter pin.
2. Remove the rod from the link.
3. Unfasten the lock nut and adjust the length of
connecting rod by turning rod.
Condition of the bucket at
full height
Bucket rolled back too far
Bucket dumped too far
4. Tighten the lock nut and set the rod to the link with the
cotter pin.
5. Start engine and set the bucket fully rolled back at the
ground.
6. Lift the boom to maximum height and check the
rollback angle.
7. If the side edge is not the same as following
illustration, repeat the steps 1 to 6 above.
Adjustment
Shorten connecting rod
Lengthen connecting rod
MAINTENANCE OF THE LOADER
(1) Link
(2) Connecting rod
(3) Lock nut

TIRE INFLATION

Insure that the tractor tires are properly inflated.
Refer to the tractor operator's manual for optional tires.
BInflation pressure
Tire sizes
12.4-16 Ind, 4PR
Rear
13.6-16, 4PR
12.4-16, 4PR
23 x 8.50-14 Ind, 4PR 241 kPa (2.5 kgf-cm , 35 psi)
Front
24 x 8.50-14, 4PR
(4) Cotter pin
(5) Rod
(A) 5 to 10

Inflation Pressure

138 kPa (1.4 kgf-cm , 20 psi)
100 kPa (1.0 kgf-cm , 14 psi)
110 kPa (1.1 kgf-cm , 16 psi)
150 kPa (1.5 kgf-cm , 22 psi)
77