3-Point Hitch (Option); Installing The Lower Link; Selecting The Holes Of Lifting Rods And Lower Links; Selecting The Top Link Mounting Holes - Kubota B26TL Operator's Manual

3-POINT HITCH (OPTION)

1. Make preparations for attaching
implement.
BInstalling the Lower Link
(1) Lower link
(2) Check chains
(3) Lynch pin
(4) Clevis pin
(5) Snap pin
BSelecting the Holes of Lifting Rods and
Lower Links
There are 2 holes in the lower links. For most operations
the lifting rods should be attached to the (A) holes.
(1) Lower links
(2) Lifting rods
A The lifting rods may be attached to (B) hole for higher
lifting height. (with reduced lifting force)
A Attach the lower links as shown above.
Holes: (A),(B)
3-POINT HITCH & DRAWBAR
BSelecting the Top Link Mounting Holes
Select the proper set of holes by referring to the
"Hydraulic Control Unit Use Reference Chart" in
"HYDRAULIC UNIT" section.
(1) Standard position
(2) Except standard position
(When standard position can not be used)
BDrawbar (option)
Remove the drawbar if close mounted implement is being
attached.
39