Dumping The Bucket; Lowering The Bucket; Operating With Float Control; Loading From A Bank - Kubota B26TL Operator's Manual

30 OPERATING THE LOADER

DUMPING THE BUCKET

Lift the bucket just high enough to clear the side of the
vehicle. Move the tractor in as close to the side of the
vehicle as possible, then dump the bucket.

LOWERING THE BUCKET

After the bucket is dumped, back away from the vehicle
while lowering and rolling back the bucket.

OPERATING WITH FLOAT CONTROL

During operation on hard surfaces, keep the bucket level
and put the lift control in the float position to permit the
bucket to float on the working surface.
If hydraulic down pressure is exerted on the bucket it will
wear faster than normal.
The float position will also avoid mixing of surface material
with stockpile material. The float position will reduce the
chance of surface gouging while removing snow or other
material, or when working with a blade.

LOADING FROM A BANK

Choose a forward gear that provides a safe ground speed
and power for loading.
To avoid serious personal injury:
A Be extra careful when working on inclines.
A When operating on a slope, always operate up
and down the slope, never across the slope.
A Loader lift and break-away capacity diminish as
loading height is increased.
Side cutting is a good technique for cutting down a big
pile. Wheel width should not exceed the bucket width for
this procedure.