Configuring Luns On Target - Chelsio Communications Chelsio T5 Installation And User Manual

Chapter X. FCoE PDU Offload Target
4.3.

Configuring LUNs on Target

i. Determine the target and initiator WWPNs using the procedure mentioned in previous
section.
ii. Create an SCST configuration file based on your setup. A sample configuration file will be
available at /etc/chelsio-fcoe/ after Unified Wire installation.
iii. Ensure that SCST handler modules, which are used in configuration (eg: scst_vdisk), are
loaded before proceeding.
iv. Configure LUNs on target by running the following command.
[root@host~]# scstadmin -config <LUN_Config_file>
Chelsio T5/T4 Unified Wire for Linux
Page 167