Auto Login From Cxgb4I Initiator At Os Bootup - Chelsio Communications Chelsio T5 Installation And User Manual

Chapter VIII. iSCSI PDU Offload Initiator
If the login fails with an error message in the format of
too big. Need to be <= <Y>
MaxRecvDataSegmentLength
setting for
node.conn[0].iscsi.MaxRecvDataSegmentLength = 8192
Always take a backup of
Important
Wire Package. Although the file is saved to
uninstalling the package using RPM, you are still advised to take a backup.
iv. Logging out from an iSCSI Target
Log out from an iSCSI Target by executing a command in the following format:
iscsiadm -m node -T <iqn name of target> -p <target ip address>:<target port
no> -I <cxgb4i iface file name> -u
E.g.:-
[root@host~]# iscsiadm -m node -T iqn.2004-05.com.chelsio.target1 -p
102.2.2.155:3260,1 -I cxgb4i.00:07:43:04:5b:da -u
Other options can be found by typing
Note
4.2.

Auto login from cxgb4i initiator at OS bootup

For iSCSI auto login (via cxgb4i) to work on OS startup, please add the following line to
start() in /etc/rc.d/init.d/iscsid
modprobe -q cxgb4i
Chelsio T5/T4 Unified Wire for Linux
. in dmesg, edit the iscsi/iscsid.conf
:
iscsid.conf
iscsiadm --help
file on RHEL:
ERR! MaxRecvSegmentLength
file and change the
file before installing Chelsio Unified
iscsid.rpmsave
<X>
after
Page 144