Chelsio Communications Chelsio T5 Installation And User Manual page 109

Chapter VII. iSCSI PDU Offload Target
Here is a sample of a minimum iSCSI target configuration located at
iscsi/chiscsi.conf
target:
TargetName=iqn.2006-02.com.chelsio.diskarray.san1
TargetDevice=/dev/sda
PortalGroup=1@192.0.2.178:3260
The TargetDevice value must match with the storage device in the system. The
value must have a matching IP address of the Ethernet adapter card in the system.
For more information about TargetDevice configuration see
Configuration.
4.3.2. Basic iSCSI Control
Control of the Chelsio iSCSI software is done through
control tool. The following are the basic commands needed for effective control of the target.
Start Target: To start all of the iSCSI targets specified in the iSCSI configuration file, execute
iscsictl "-S"
with the
[root@host~]# iscsictl –S target=ALL
To start a specific target execute
[root@host~]# iscsictl –S target=iqn.2006-02.com.chelsio.diskarray.san1
Stop Target: To stop the all the iSCSI target(s), execute
" ".
target=ALL
[root@host~]# iscsictl –s target=ALL
To stop a specific target execute
[root@host~]# iscsictl –s target=iqn.2006-02.com.chelsio.diskarray.san1
Chelsio T5/T4 Unified Wire for Linux
:
option followed by "
iscsictl
iscsictl
iscsictl
".
target=ALL
with " " followed by the target.
-S
iscsictl
with " " followed by the target name.
-s
/etc/chelsio-
PortalGroup
Target Storage Device
, the command line interface
with " " option followed by
-s
Page 109