I ns Tall aTIon of I-PI loT l In K Co n T Ro l l e R
For PowerDrive V2 and Riptide SP trolling motors go to page 12.
i-Pilot Link Installation on Terrova and
Riptide ST Trolling Motors
* i-Pilot Link will override all CoPilot functionality. CoPilot remotes will not
function with i-Pilot Link.
* The Terrova foot pedal is fully functional and supported when i-Pilot Link
is installed correctly.
1. Remove all power to the trolling motor.
2. Remove control box cover screws and cover using Phillips
screwdriver. (figure 1)
3. If the trolling motor has the AutoPilot feature, unplug the
AutoPilot control board and remove it from the control box.
(figures 2 and 3)
4. Remove grommet by pulling back on coil cord strain relief and
pushing down on grommet. (figure 4)
INSTALLATION
FIGURE 1
FIGURE 2
FIGURE 3
Grommet
FIGURE 4
mi nn kot a m ot or s . com
9