Installation; Setup; Connecting; Location - Philips NetCam DVR Installation Instructions Manual

DVR_NC_ii_98911_0047.qxd
NetCam DVR
2

INSTALLATION

2.1

Setup

Connect Ethernet and Power to NetCam DVR on local network for
I
configuration.
Install the setup program for NetCam DVR.
I
Assign an IP address to NetCam DVR and configure administrator's
I
condition.
Configure user's condition.
I
Locate NetCam DVR, and re-connect power and Ethernet.
I
Adjust the Focus.
I
2.1.1

Connecting

Connect Ethernet line to the Ethernet port in the rear.
I
Connect the power supply to a power supply port in the rear.
I
Confirm that the green LED of the Ethernet port blinks
I
2.1.2

Location

Place NetCam DVR appropriately for your purpose
I
Wa rning: Do not expose the camera lens to direct sunlight. When you operate
NetCam DVR in the glaring light, we recommend using an auto iris lens.
12/13/00 1:53 PM Page 11
Section 2
11