Philips NetCam DVR Installation Instructions Manual page 17

DVR_NC_ii_98911_0047.qxd 12/13/00 1:53 PM Page 17
NetCam DVR Section 2
Setting IP security mode
You can restrict accessibility to the NetCam DVR with user' IP address
registering. Only the users whose PC's IP address is registered can access the
NetCam DVR.
You may stop a registered user accessing the NetCam DVR temporary with the
menu option on the right side of each IP address. You can change the IP
addresses to allow access.
If you inactivate the 'Secure Mode' (IP filtering) option, you can access the
NetCam DVR by installing the NetCam DVR Viewer into any PC.
Setting information on channels and HDD
Channel Use: You select the channels
to display live images and to record
them on the NetCam DVR's self-
contained HDD. When you
connect an external CCD camera to
Ch1 port on the rear of the NetCam
DVR, you can select 'External' for
Channel 1. Otherwise, select
'internal'. You can also select one or
more channels as a video source. For
external channels, it is very
important you should check only the
channels that are connected with
external cameras. Otherwise, all live
and recorded images may flicker.
Camera Config: Define the CCD format of the NetCam DVR and CCD
cameras ['NTSC' or 'PAL']. You can rotate the image by 180°. If you rotate the
image that is sent from each camera, you can mount the NetCam DVR directly
on the ceiling [i.e. upside down].
17