Table of Contents
Advertisement
NetCam_ii_99011_0047.qxd
NetCam4
2
INSTALLATION
2.1
Setup
Connect Ethernet and Power to NetCam4 on local network for
I
configuration.
Install the setup program for NetCam4.
I
Assign an IP address to NetCam4 and configure administrator's condition.
I
Configure user's condition.
I
Locate NetCam4, and re-connect power and Ethernet.
I
Adjust the Focus.
I
2.1.1
Connecting
Connect Ethernet line to the Ethernet port in the rear.
I
Connect the power supply to a power supply port in the rear.
I
Confirm that the green LED of the Ethernet port blinks
I
2.1.2
Location
Place NetCam4 appropriately for your purpose
I
Wa rning: Do not expose the camera lens to direct sunlight. When you operate
NetCam4 in the glaring light, we recommend using an auto iris lens.
12/13/00
1:54 PM
Page 11
Section 2
11
Advertisement
Table of Contents
