Related Manuals for Bel Canto e.One Phono
Summary of Contents for Bel Canto e.One Phono
-
Page 2: Declaration Of Conformity
Bel Canto Design Limited. Bel Canto Design Limited assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual. Trademarks used in this publication: Bel Canto and the Bel Canto logo are registered trademarks of Bel Canto Design Limited. - Page 3 Fit a new 10 amp BS1362 approved fuse into the carrier and push the carrier back into the plug. Always ensure the fuse cover is fitted. If the fuse cover is missing do not use the plug. Contact your Bel Canto retailer to obtain a replacement fuse cover.
- Page 4 5 business days you will receive an email that officially validates your warranty. Your information will be used for internal use only and will not be sold or released outside Bel Canto. Your comments and suggestions are appreciated and help us continually improve our products and services.
- Page 5 • IEC power cord jack: Connect the supplied or a quality aftermarket power cord from this jack. Note the power setting indicated on the back of the unit before connecting the power • Ground: If your turntable has a grounding wire, try connecting it to this post. In many but not all cases, this will eliminate the electrical hum that may be present in your signal •...
- Page 6 Switch Settings A set of 6 switches are located next to each RCA input. These are used to setup the optimum Gain, Resistive Load, and Capacitive Load for your cartridge. Please refer to your cartridge manual for the optimum gain and RC loading recommendations.
- Page 7 Refer to these charts when adjusting the dip switches. Gain Adjustment Switch 1 Switch 2 Gain dB 38dB MM Down 50dB MC Low Down 58dB MC Down Down 60dB MC High Resistance Adjustment Effective Load Resistance 1000 (ohms) Down Down Down Down Down Down...
- Page 8 Bandwidth: 1Hz-50KHz RIAA Accuracy: 20Hz-20KHz +/- 0.2 dB Signal to Noise Ratio 40 dB gain: >80 dB A weighted, re 5mV RMS in Distortion @ 2 Volt RMS/1kHz: <0.01% Maximum Output Level: 7 V RMS Output Impedance: 100 Ohms Single Ended and Balanced Input Impedance: Adjustable See page 6 Gain Level Options:...
- Page 9 EN 55013:2001 + A1:2003 + A2:2006 EN 55020:2007 EN 61000-3-2:2006 EN 61000-3-3:1995 + A1:2001 + A2:2005 EN 60065:2002/A12:2011 Manufacturer: Bel Canto Design, Ltd. 221 1 Street North Minneapolis, MN 55401 USA The equipment identified here conforms to the Directive(s) and Standard(s) specified above.
- Page 10 2.0...