Network Setting - Hall Research Technologies HSM-88-4K User Manual

HSM-88-4K
The matrix can be controlled using the Windows GUI via a Serial port (COM Control
Mode) or over the network (TCP Control Mode).
Select the appropriate mode in the Setup tab to control the matrix. Note that you
need to allow this application in your firewall to communicate over network. The
GUI updates in real time to the changes made to the unit from the front panel,
RS232 and telnet. The following are some of the major feature available in
Windows GUI.

Control the matrix using Serial RS232 or the network. The status of the
input and output HDMI can be seen under Device Information in the
setup tab.

Matrix tab shows the current routing configuration and updates in real
time. The user can also enable/disable Audio Return Channel (ARC) for
each output.

Presets tab includes preset save, preset edit and preset recall.

EDID tab lets you load a custom EDID to any source connected to the
matrix's input ports. You can also copy the EDID from any display
connected to the output to an input. All the EDID management can be
done from the EDID tab.

6.0 Network Setting

As shipped from the factory (or after restoring factory defaults), the HSM-88-4K
IP address is set for static IP address as 192.168.1.50.
(A) DHCP
Click on the "Network Settings" tab to change the network settings
for the matrix. You can manually set the IP address, netmask and
gateway address in "Static IP" mode, or you can obtain an IP address
14
© Copyright 2017 Hall Research, Inc.
HSM-88-4K – Network Settings