Changing Needle; Insert "Darning Plate - Siruba HSM-2722 Instruction

CHANGING NEEDLE

INSERT "DARNING PLATE"

Needle clamp screw
Tighten
Loosen
Flat face side away
from you
Warning: Before changing the pin
please adjust main control switch to
(O).
1. Raise the needle bar to its highest
position.
2. Loosen needle clamp screw and
remove the old needle.
3. With the flat side of the needle facing
away from you, insert the needle as
far up as it will go.
4. Tighten the needle clamp screw
securely.
Sometimes you will want to control the
feeding of fabric yourself. Turn the
needle bar to its highest position and
raise the presser foot over the needle
plate, aligning two pins of the darning
plate with holes of needle plate. You
may then determine the movement of
the fabric by yourself. See page 26 for
button sewing application.
- 16 -