Table of Contents
Advertisement
6-1 Before Getting Started
6-2 Preparing to Adjust the Settings with a Cable Connection
Å Connections
ı Starting the AP-3
and computer
AP-3 SETTINGS
Disconnect the network computers from the AP-3 unit
if you are starting up the AP-3 unit for the first time
after purchasing it or after initializing all setting data.
Connect only the computer than will be used for to
adjust the settings. The connection can be wired or
wireless.
If the AP-3 unit is connected to a working network with-
out changing the original factory settings, IP address
conflicts and other network problems may occur.
[NOTE]
If possible, use a cable connection between the AP-3 and the com-
puter used to adjust the settings.
See "4-1 Connecting to a Computer" (
how to connect the computer to the AP-3.
Setting terminal
1. After connecting the cable, connect the provided AC
adapter to the DC jack of the AP-3 and plug it into an
outlet. The AP-3 unit will power on. (
16)
• At first all lamps on the front panel will illuminate, then
only the [POWER] lamp will remain on.
2. Start up the computer.
• If the connection is established normally, the [LAN]
lamp (
p. 6) on the front panel of the AP-3 will illu-
minate.
* If the [LAN] lamp does not illuminate set the
[HUB/PC] switch to [PC]. (
[IMPORTANT]
When the computer is connected to the AP-3 through a hub, do not
start up any computer other than the computer being used to adjust
the settings (setting terminal) until the settings are completed.
p. 14) regarding
Ethernet cable
AP-3
section 4-3, p.
pp. 6 and 14)
6
37
Advertisement
Table of Contents
