Panel Description; Front And Rear Panels - Icom AP-3 Instruction Manual

2

PANEL DESCRIPTION

Front and rear panels

Front panel
Rear panel
q [POWER] lamp ·········
w [LAN] lamp ···············
e
6
DC
This lamp illuminates when the power to the AP-3 unit is
on.
This lamp flashes slowly when the unit is in [Initialize
mode] (
Mode] (
This lamp illuminates when the wired LAN (Ethernet) con-
nection is normal.
This lamp flashes when the AP-3 unit is communicating
with a wired LAN or wireless LAN.
This lamp goes out if the [ETHERNET] port on the rear
panel can not recognize the LAN connection. In this case,
check the connection of the Ethernet cable and the set-
ting of the [HUB/PC] switch. (
This lamp illuminates when the wireless connection to the
lamp····
AP-3 unit is normal.
This lamp goes out if a wireless communication abnor-
mality occurs. The lamp will also go out if all wireless ter-
minals are inactive for more than one or two minutes or
move out of the wireless communication area for more
than one or two minutes.
If this lamp does not illuminate, check such items as the
IP address of the wireless terminal, the [Network Mode]
and [ESS ID] (
in the wireless terminal, and the [MAC Address Security]
settings (if used).
* This lamp cannot be used to determine whether or not
the LAN card is installed into the PCMCIA slot.
LAN
POWER LAN wireless LAN
ETHERNET
HUB PC
MODE INIT RESET
p. 63) and rapidly when the unit is in [Update
p.68).
p. 38) of the wireless LAN card installed
WIRELESS LAN CARD
p. 8, 14, 15)