Operating Instructions; Operating Position - Poulan Pro 115224926 Instruction Manual

WARNING:
connect spark plug before removing or instal-
ling attachments.
REMOVING PRUNER ATTACH-
MENT, LINE TRIMMER ATTACH-
MENT, OR OTHER OPTIONAL AT-
TACHMENTS
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Attachment
2. Press and hold the locking/release button.
Locking/Release
Button
Attachment
Coupler
3. While securely holding the engine end shaft
and extension shaft, pull the attachment
straight out of the extension shaft coupler.
4. Repeat steps to remove extension shaft
from coupler on engine end shaft.
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the attach-
ment (if present).
2. Position locking/release button of attach-
ment into guide recess of coupler on engine
end shaft.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler Primary Hole
Upper
Shaft
WARNING:
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. All attachments are designed
to be used in the primary hole unless otherwise
Always stop unit and dis-
LOOSEN
Knob
TIGHTEN
Upper Shaft
Guide Recess
Locking/
Attachment
Release
Button
Make sure the locking/
stated in the applicable attachment instruction
manual. Using the wrong hole could lead to seri-
ous injury or damage to the unit.
Locking/Release
Button in Primary Hole
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for storage
when attachment is not in use.
To install hanger on attachment:
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release button.
3. Push hanger onto the attachment until the
locking/release button snaps into the hole.

OPERATING INSTRUCTIONS

It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.
OPERATING INSTRUCTIONS FOR
PRUNER ATTACHMENT

OPERATING POSITION

ALWAYS WEAR:
Head
protection Eye
protection
Long pants
DANGER:
shoulders while pruning. Do not stand be-
neath branch being cut.
WARNING:
hearing, foot and body protection to reduce
the risk of injury when operating this unit.
When operating unit, clip shoulder strap onto
clamp, stand as shown and check for the fol-
lowing:
S Extend your left arm and hold assist handle
with your left hand.
S Hold throttle grip with your right hand with
finger on throttle trigger.
S Keep engine end below waist level.
14
Heavy
shoes
Do not extend arms above
Always wear head, eye,